LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 245 (Tire And Wheel) >> TIRE PRESSURE WARNING RECEIVER (for Sedan) >> Installation

TIRE PRESSURE WARNING RECEIVER (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY (w/ Antenna) 
    1. Engage the clip and install the tire pressure warning receiver.
      2. Fig 1: Identifying Tire Pressure Warning Receiver Assembly Bolts With Clip
      G05591503Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the bolt.

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

    3. Connect the tire pressure warning receiver connector.
  2. INSTALL ROOF SIDE INNER GARNISH RH  (See INSTALLATION )
  3. INSTALL REAR SEAT SIDE COVER RH  (See INSTALLATION )
  4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH  (See INSTALLATION )
  5. INSTALL REAR DOOR SCUFF PLATE RH  (See INSTALLATION )
  6. INSTALL REAR SEATBACK ASSEMBLY RH (for 60/40 Split Seat Type)  (See INSTALLATION )
  7. INSTALL REAR SEATBACK ASSEMBLY LH (for 60/40 Split Seat Type)  (See INSTALLATION )
  8. INSTALL REAR SEATBACK ASSEMBLY (for Fixed Seat Type)  (See INSTALLATION )
  9. INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY  (See INSTALLATION )
  10. INSPECT TIRE PRESSURE WARNING SYSTEM 

    (See TEST MODE PROCEDURE  )

scientia non olet · About LEMON Manuals