REAR WIPER MOTOR (for Hatchback): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE BACK DOOR TRIM BOARD ASSEMBLY (See DISASSEMBLY )
REMOVE REAR WIPER ARM AND BLADE ASSEMBLY
1. Remove the rear wiper arm head cap.
  
  Fig 1: Identifying Rear Wiper Arm Head Cap
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the nut and rear wiper arm and blade.
  
  Fig 2: Identifying Nut And Rear Wiper Arm And Blade
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR WIPER MOTOR GROMMET
1. Remove the rear wiper motor grommet.
  
  Fig 3: Identifying Rear Wiper Motor Grommet
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR WIPER MOTOR
1. Disconnect the connector.
2. Loosen bolt A.
  NOTE: Do not try to remove the bolt since it is integrated with the motor.
3. Remove bolt B and the rear wiper motor.
  
  Fig 4: Identifying Bolt B And Rear Wiper Motor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002