LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 ((Door / Hatch)) >> BACK DOOR (for Hatchback) >> Disassembly

BACK DOOR (for Hatchback): Disassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE CENTER STOP LIGHT COVER (See  REMOVAL  ) 
  3. REMOVE HIGH MOUNTED STOP LIGHT ASSEMBLY (See  REMOVAL  ) 
  4. REMOVE BACK DOOR TRIM BOARD ASSEMBLY 
    1. Using a screwdriver with its tip wrapped in protective tape, slide the handle plate of the back door trim board to disengage it.
      Fig 1: Sliding Handle Plate Of Back Door Trim Board
      G04835016Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 3 claws and 9 clips and remove the back door trim board.
  5. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY (See  REMOVAL  ) 
  6. REMOVE REAR WIPER MOTOR GROMMET (See  REMOVAL  ) 
  7. REMOVE REAR WIPER MOTOR (See  REMOVAL  ) 
    Fig 2: Identifying Claws & Clips Location
    G04835017Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE BACK DOOR PANEL NO.2 PROTECTOR 
    1. Disengage the claw and clip, then remove back door panel protector No. 2.
      NOTE: Remove any tape remaining on the back door side.
  9. REMOVE BACK DOOR PANEL NO.1 PROTECTOR 

    HINT:

    Use the same procedure as described for the No. 2 side.

  10. REMOVE BACK DOOR LOCK ASSEMBLY (See  INSPECTION  ) 
    Fig 3: Identifying Claws & Clips Location
    G04835018Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE BACK DOOR LOCK CYLINDER ASSEMBLY 
    1. Remove the bolt and back door lock cylinder assembly.
      Fig 4: Locating Bolt & Back Door Lock Cylinder Assembly
      G04835019Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE BACK DOOR OUTSIDE HANDLE 
    1. Remove the back door outside handle from the back door panel.
      Fig 5: Locating Back Door Outside Handle
      G04835020Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. REMOVE BACK DOOR LOCK ACTUATOR ASSEMBLY 
    1. Disconnect the connector.
    2. Remove the 2 bolts and the back door lock actuator.
  14. REMOVE REAR SPOILER COVER LH (See  REMOVAL  ) 
  15. REMOVE REAR SPOILER COVER RH (See  REMOVAL  ) 
  16. REMOVE REAR SPOILER (See  REMOVAL  ) 
    Fig 6: Locating Bolts & Back Door Lock Actuator
    G04835021Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  17. REMOVE NO. 1 LUGGAGE COMPARTMENT DOOR NAME PLATE (See  REMOVAL  ) 
  18. REMOVE NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE (See  REMOVAL  ) 
  19. REMOVE SYMBOL EMBLEM (See  REMOVAL  ) 
scientia non olet · About LEMON Manuals