REAR WIPER MOTOR (for Hatchback): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR WIPER MOTOR
1. Install the rear wiper motor with the 3 bolts.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  
  Fig 1: Identifying Rear Wiper Motor With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the connector.
INSTALL REAR WIPER MOTOR GROMMET
1. Install the rear wiper motor grommet.
  
  Fig 2: Identifying Rear Wiper Motor Grommet
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
1. Scrape any metal powder off the serrated part of the wiper arm with a round file or the equivalent (when reinstalling).
2. Clean the wiper pivot serrations with a wire brush.
3. Operate the wiper, then stop the windshield wiper motor in the automatic stop position.
4. Install the rear wiper arm into the position shown in the illustration with the nut.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  
  HINT:
  
  Hold the arm hinge down by hand while tightening the nut.
  
  Fig 4: Identifying Rear Wiper Arm Into Position
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Install the rear wiper arm head cap.
Fig 5: Identifying Rear Wiper Arm Head Cap
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BACK DOOR TRIM BOARD ASSEMBLY (See DISASSEMBLY )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)