Speed Sensor: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL SPEEDOMETER DRIVEN GEAR
1. Coat a new O-ring with ATF and install it onto the speedometer sensor.
2. Install the driven gear into the speedometer sensor with the clip.
  
  Fig 1: Identifying O-Ring And Speedometer Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL SPEEDOMETER SENSOR
1. Install the speedometer sensor with the bolt.
  Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)
  
  Fig 2: Identifying Bolt And Speedometer Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the speedometer sensor connector.
INSTALL BATTERY CARRIER (See INSTALLATION )
INSTALL BATTERY TRAY
INSTALL BATTERY (See INSTALLATION )
INSTALL OUTER COWL TOP PANEL
Hatchback: (See INSTALLATION )

Sedan: (See INSTALLATION )
INSTALL COWL TO REGISTER DUCT SUBASSEMBLY (for Hatchback) (See INSTALLATION )
INSTALL FRONT AIR SHUTTER SEAL (for Sedan) (See INSTALLATION )
INSTALL FRONT WIPER MOTOR AND LINK
Hatchback: (See INSTALLATION )

Sedan: (See INSTALLATION )
INSTALL COWL TOP VENTILATOR LOUVER LH (for Hatchback) (See INSTALLATION )
INSTALL COWL TOP VENTILATOR LOUVER SUBASSEMBLY
Hatchback: (See INSTALLATION )

Sedan: (See INSTALLATION )
INSTALL HOOD TO COWL TOP SEAL (for Hatchback) (See INSTALLATION )
INSTALL COWL SIDE VENTILATOR SUB-ASSEMBLY LH (for Sedan) (See INSTALLATION )
INSTALL COWL SIDE VENTILATOR SUB-ASSEMBLY RH (for Sedan) (See INSTALLATION )
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH
Hatchback: (See INSTALLATION )

Sedan: (See INSTALLATION )
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH
Hatchback: (See INSTALLATION )

Sedan: (See INSTALLATION )
INSTALL FRONT WIPER ARM HEAD CAP
Hatchback: (See INSTALLATION )

Sedan: (See INSTALLATION )