LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Automatic Transmission - U340E) >> Floor Shift Assembly >> Removal

Floor Shift Assembly: Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 
    1. Remove the shift lever knob sub-assembly from the shift lever.
  3. REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL (for Sedan)  (See REMOVAL )
  4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan)  (See REMOVAL )
  5. REMOVE REAR CONSOLE BOX COVER (for Hatchback)  (See REMOVAL )
  6. REMOVE REAR UPPER CONSOLE PANEL SUBASSEMBLY (for Sedan)  (See REMOVAL )
  7. REMOVE CONSOLE BOX CARPET  (See REMOVAL )
  8. REMOVE REAR CONSOLE BOX ASSEMBLY  (See REMOVAL )
  9. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Disconnect the control cable from the shift lever.
      Fig 1: Identifying Control Cable
      G04831143Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Turn the nut and separate the control cable from the shift lever retainer.
    Fig 2: Identifying Nut
    G04831144Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE FLOOR SHIFT ASSEMBLY 
    1. Separate the shift lock control computer connector and indicator wire connector.
    2. Separate the 2 wire harness clamps from the shift lever.
    3. Remove the 4 bolts and remove the shift lever.
      Fig 3: Identifying Bolts And Shift Lever
      G04831161Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals