Differential Oil Seal: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT TRANSAXLE CASE OIL SEAL
1. Coat the lip of a new oil seal with MP grease.
2. Using SST and a hammer, install the front transaxle case oil seal.
  SST 09554-14010, 09950-70010 (09951-07200)
  
  Drive in depth:
  
  1.5 to 2.5 mm (0.059 to 0.098 in.)
  
  NOTE: Do not damage the oil seal lip.
  
  Fig 1: Identifying Front Transaxle Case Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSAXLE CASE OIL SEAL
1. Coat the lip of a new oil seal with MP grease.
2. Using SST and a hammer, install the transaxle case oil seal.
  SST 09710-20011 (09710-06071), 09950-70010 (09951-07200)
  
  Drive in depth:
  
  5.4 to 6.4 mm (0.213 to 0.252 in.)
  
  NOTE: Do not damage the oil seal lip.
  
  Fig 2: Identifying Transaxle Case Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DRIVE SHAFT ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT DRIVE SHAFT ASSEMBLY RH (See INSTALLATION )
INSTALL TRANSMISSION CASE PROTECTOR (w/o ABS)
1. Install the transmission case protector onto the automatic transaxle with the 2 bolts.
Fig 3: Identifying Bolts And Transmission Case Protector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT LOWER SUSPENSION ARM LH (See INSTALLATION )
INSTALL FRONT LOWER SUSPENSION ARM RH
HINT:

The installation procedure for the RH side is the same as that for the LH side.
INSTALL TIE ROD END SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL TIE ROD END SUB-ASSEMBLY RH
HINT:

The installation procedure for the RH side is the same as that for the LH side.
INSTALL FRONT STABILIZER LINK ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT:

The installation procedure for the RH side is the same as that for the LH side.
INSTALL FRONT SPEED SENSOR LH (w/ ABS) (See INSTALLATION )
INSTALL FRONT SPEED SENSOR RH (w/ ABS)
HINT:

The installation procedure for the RH side is the same as that for the LH side.
INSTALL FRONT AXLE HUB NUT LH (See INSTALLATION )
INSTALL FRONT AXLE HUB NUT RH
HINT:

The installation procedure for the RH side is the same as that for the LH side.
Install front wheels
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
ADD AUTOMATIC TRANSAXLE FLUID (See INSTALLATION )
INSPECT AUTOMATIC TRANSAXLE FLUID (See AUTOMATIC TRANSAXLE FLUID )
CHECK AUTOMATIC TRANSAXLE FLUID LEAKAGE
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(See ADJUSTMENT )
INSTALL ENGINE UNDER COVER RH
INSTALL ENGINE UNDER COVER LH