LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 236 (Door Lock) >> Door Control Receiver >> Removal

Door Control Receiver: Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE REAR DOOR SCUFF PLATE RH 
    1. Using a screwdriver, detach the 9 claws.

      HINT:

      Tape the screwdriver tip before use.

    2. Using a clip remover, detach the 2 clips and remove the garnish.
      3. Fig 1: Attaching Claws And Clips To Installing Scuff Plate
      G05586185Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH 
  3. REMOVE REAR FLOOR NO. 1 BOARD (w/o Rear No. 2 Seat) 
  4. REMOVE DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat) 
  5. REMOVE NO. 2 SEAT HINGE COVER LH (w/ Rear No. 2 Seat)  (See REMOVAL )
  6. REMOVE NO. 2 SEAT HINGE COVER RH (w/ Rear No. 2 Seat) 

    HINT:

    Use the same procedures described for the LH side.

  7. REMOVE NO. 2 SEAT LEG COVER LH (w/ Rear No. 2 Seat)  (See REMOVAL )
  8. REMOVE NO. 2 SEAT LEG COVER RH (w/ Rear No. 2 Seat) 

    HINT:

    Use the same procedures described for the LH side.

  9. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (w/ Rear No. 2 Seat)  (See REMOVAL )
  10. REMOVE REAR NO. 2 SEAT ASSEMBLY RH (w/ Rear No. 2 Seat) 
  11. REMOVE REAR FLOOR NO. 3 BOARD 
  12. REMOVE REAR FLOOR NO. 2 BOARD 
  13. REMOVE REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE  (See REMOVAL )
  14. REMOVE REAR FLOOR FINISH PLATE  (See REMOVAL )
  15. REMOVE REAR DECK TRIM COVER RH (w/ Rear No. 2 Seat) 
    1. Remove the bolt.
    2. Using a screwdriver, detach the 4 claws and remove the trim cover.

      HINT:

      Tape the screwdriver tip before use.

  16. REMOVE RECLINING REMOTE CONTROL LEVER BEZEL RH (w/o Rear No. 2 Seat)  (See REMOVAL )
  17. REMOVE TETHER ANCHOR BRACKET SUB-ASSEMBLY (w/o Rear No. 2 Seat) 
    1. Remove the bolt and tether anchor bracket.
      2. Fig 2: Installing Tether Anchor Bracket With Bolt
      G05586186Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  18. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (w/o Rear No. 2 Seat)  (See REMOVAL )
  19. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (w/ Rear No. 2 Seat)  (See REMOVAL )
  20. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH (w/o Rear No. 2 Seat) 
    1. Using a clip remover, detach the 7 clips and remove the garnish.
      Fig 3: Attaching Clips To Installing Garnish (W/O Rear No. 2 Seat)
      G05586187Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  21. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH (w/ Rear No. 2 Seat) 
    1. Disconnect the rear No. 2 seat outer belt's shoulder anchor.
      1. Using a screwdriver, detach the 2 claws and open the seat belt anchor cover.

        HINT:

        Tape the screwdriver tip before use.

      2. Remove the bolt and disconnect the shoulder anchor.
        Fig 4: Disconnecting Rear No. 2 Seat Outer Belt's Shoulder Anchor
        G05586188Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a clip remover, detach the 7 clips and remove the garnish.
      Fig 5: Attaching 7 Clips To Installing Garnish (W/Rear No. 2 Seat)
      G05586189Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  22. REMOVE DOOR CONTROL RECEIVER 
    1. Disconnect the receiver connector.
    2. Remove the bolt and receiver.
      Fig 6: Installing Door Control Receiver
      G05586190Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals