Diaphragm Oil Seal: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL DIAPHRAGM OIL SEAL
1. Apply a light coat of MP grease No. 2 to the lip of a new diaphragm oil seal.
2. Using SST and a hammer, tap the diaphragm oil seal into the rear differential carrier according to the specification.
  SST 09710-30021 (09710-03121), 09950-60010 (09951-00570), 09950-70010 (09951-07100)
  
  Standard distance: 7.0 +-0.5 mm (0.28 +-0.02 in.)
  
  Fig 1: Installing Diaphragm Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSMISSION COUPLING SHIM (See REASSEMBLY )
INSTALL TRANSMISSION COUPLING CONICAL SPRING WASHER (See REASSEMBLY )
INSTALL YOKE (See REASSEMBLY )
INSTALL 4WD LINEAR SOLENOID (See REASSEMBLY )
INSTALL ELECTROMAGNETIC COUPLING (See REASSEMBLY )
TEMPORARILY INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (See INSTALLATION )
FULLY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (See INSTALLATION )
INSPECT AND ADJUST JOINT ANGLE (See INSPECTION )
ADD DIFFERENTIAL OIL
1. Add differential oil (see DIFFERENTIAL OIL ).
INSPECT FOR DIFFERENTIAL OIL LEAK
If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.