UNDERDRIVE Planetary Gear: Disassembly
WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT UNDERDRIVE PLANETARY GEAR PRELOAD (See INSPECTION )
- REMOVE CYLINDRICAL ROLLER BEARING RACE INNER
- Using SST, loosen the staked part of the nut.
SST 09930-00010 (09931-00010, 09931-00020), 09387-00050
- Clamp the underdrive planetary gear in soft jaw vise.NOTE: Be careful not to damage the differential drive pinion.
- Using SST, remove the lock nut.
SST 09564-16020
- Using SST, remove the cylindrical roller bearing inner race.
SST 09950-00020, 09950-00030, 09950-60010 (09951-00340)
- Using SST, loosen the staked part of the nut.
- REMOVE UNDERDRIVE PLANETARY GEAR ASSEMBLY
- Using SST and a press, remove the differential drive pinion, parking lock gear, counter driven gear with underdrive planetary ring gear and front tapered roller bearing.
SST 09387-00050
- Clamp the underdrive planetary gear in soft jaw vise.
- Using SST, remove rear tapered roller bearing from the underdrive planetary gear.
SST 09950-00020, 09950-00030, 09950-60010 (09951-00320)
- Using SST and a press, remove the differential drive pinion, parking lock gear, counter driven gear with underdrive planetary ring gear and front tapered roller bearing.
- REMOVE UNDERDRIVE PLANETARY RING GEAR
- Using snap ring pliers, remove the snap ring.
- Remove the underdrive planetary ring gear from the counter driven gear.