Transmission Wire: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSMISSION WIRE
1. Coat a new O-ring of the transmission wire connector with ATF.
  
  Fig 1: Identifying Transmission Wire O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the transmission wire.
3. Install the bolt.
4. Connect the connector.
5. Coat the O-ring of the ATF temperature sensor with ATF.
6. Install the ATF temperature sensor with the lock plate and bolt.
  Torque: 6.6 N*m (67 kgf*cm, 58 in.*lbf)
  
  Fig 3: Identifying Bolt And Lock Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Connect the 5 shift solenoid valve connectors.
INSTALL AUTOMATIC TRANSAXLE OIL PAN SUBASSEMBLY
1. Install the 3 magnets in the oil pan.
  
  Fig 4: Identifying Magnets
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install a new gasket and the oil pan with the 18 bolts.
  Torque: 7.6 N*m (77 kgf*cm, 67 in.*lbf)
  
  Fig 5: Identifying Oil Pan Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 ENGINE UNDER COVER
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
ADD AUTOMATIC TRANSAXLE FLUID
Fluid type:

Toyota Genuine ATF WS or Equivalent
INSPECT TRANSAXLE FLUID LEVEL
1. Inspect the fluid level (see ON-VEHICLE INSPECTION ).