LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 228 (Transfer Case -GF1A- RAV4) >> 4WD Control Ecu >> Removal

4WD Control Ecu: Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY  (See REMOVAL )
  3. REMOVE 4WD CONTROL ECU 
    1. Disconnect the connector.
    2. Remove the bolt and ECU.
      Fig 1: Locating 4WD Control ECU Bolt
      G05584740Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals