LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 225 (Air Conditioning) >> AIR CONDITIONING PANEL (for Manual Air Conditioning System) >> Installation

AIR CONDITIONING PANEL (for Manual Air Conditioning System): Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL AIR VENT MODE CONTROL SWITCH 
    1. Attach the 2 claws to install the mode control switch.
  2. INSTALL BLOWER CONTROL SWITCH 
    1. Attach the 2 claws to install the blower control switch.
  3. INSTALL AIR MIX CONTROL SWITCH 
    1. Attach the 2 claws to install the air mix control switch.
  4. INSTALL AIR CONDITIONING CONTROL ASSEMBLY 
    1. Connect the connectors.
    2. Attach the 3 clips to install the air conditioning control.
    3. Install the 2 screws.
      4. Fig 1: Identifying Air Conditioning Control Assembly And Screws
      G05585482Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL RADIO RECEIVER ASSEMBLY (w/ Radio Receiver)  (See INSTALLATION )
  6. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER  (See INSTALLATION )
  7. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL CENTER  (See INSTALLATION )
  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  9. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).
scientia non olet · About LEMON Manuals