LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 223 (Engine Control System (2GR-FE)) >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM  (See REPLACEMENT )
  2. DRAIN ENGINE COOLANT  (See REPLACEMENT )
  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  4. REMOVE RADIATOR ASSEMBLY 
    1. Remove the radiator assembly (see REMOVAL ).
  5. REMOVE FAN AND GENERATOR V BELT  (See REMOVAL )
  6. DISCONNECT COMPRESSOR WITH PULLEY ASSEMBLY  (See REMOVAL )
  7. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the bolt and sensor.
      Fig 1: Identifying Crankshaft Position Sensor And Bolt
      G05184269Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals