Luggage Room Light: Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE BACK DOOR CENTER GARNISH (See DISASSEMBLY )
REMOVE BACK DOOR SIDE GARNISH LH (See DISASSEMBLY )
REMOVE BACK DOOR SIDE GARNISH RH (See DISASSEMBLY )
REMOVE BACK DOOR TRIM BOARD (See DISASSEMBLY )
REMOVE BACK DOOR COURTESY LIGHT ASSEMBLY
1. Using a screwdriver, pry out the light as shown in the illustration.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 1: Removing Back Door Courtesy Light
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Detach the 4 claws and remove the light shade.
  
  Fig 2: Identifying Light Shade Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the light bulb from the light.
  
  Fig 3: Identifying Light Bulb
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002