LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (Lighting) >> License Plate Light Assembly >> Removal

License Plate Light Assembly: Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE BACK DOOR CENTER GARNISH  (See DISASSEMBLY )
  3. REMOVE BACK DOOR SIDE GARNISH LH  (See DISASSEMBLY )
  4. REMOVE BACK DOOR SIDE GARNISH RH  (See DISASSEMBLY )
  5. REMOVE BACK DOOR TRIM BOARD  (See DISASSEMBLY )
  6. REMOVE BACK DOOR LOWER OUTSIDE GARNISH SUB-ASSEMBLY LH  (See DISASSEMBLY )
  7. REMOVE LICENSE PLATE LIGHT ASSEMBLY 
    1. Disconnect the connector.
    2. Using a screwdriver, remove the light as shown in the illustration.
      Fig 1: Removing License Plate Light Using Screwdriver
      G05586011Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals