Fog Light Assembly: Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH and LH sides.
The procedures listed below are for the LH side.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE FRONT FENDER LINER LH (See REMOVAL )
REMOVE FRONT FENDER LINER RH (See REMOVAL )
REMOVE RADIATOR SUPPORT OPENING COVER (See REMOVAL )
REMOVE FRONT BUMPER COVER (See REMOVAL )
REMOVE FOG LIGHT ASSEMBLY
1. Disconnect the connector.
2. Remove the bolt and fog light.
Fig 1: Identifying Fog Light Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002