LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (Audio System & Visual System) >> Back Door Speaker >> Removal

Back Door Speaker: Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE BACK DOOR CENTER GARNISH  (See DISASSEMBLY )
  2. REMOVE BACK DOOR SIDE GARNISH LH  (See DISASSEMBLY )
  3. REMOVE BACK DOOR SIDE GARNISH RH  (See DISASSEMBLY )
  4. REMOVE BACK DOOR TRIM BOARD  (See DISASSEMBLY )
  5. REMOVE REAR STEREO COMPONENT SPEAKER ASSEMBLY 
    1. Disconnect the connector.
    2. Using a drill bit with a diameter of less than 4 mm (0.16 in.), drill out the 3 rivet heads and remove the speaker.
      NOTE:
      • Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.
      • Be careful as the cut rivet will be very hot.
        Fig 1: Drilling Out Rivet Heads Using Drill
        G05184900Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Continue drilling and push out the remaining rivet fragments.
    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.
scientia non olet · About LEMON Manuals