LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Seat Belt) >> REAR SEAT OUTER BELT ASSEMBLY (for Hatchback 5 Door) >> Removal

REAR SEAT OUTER BELT ASSEMBLY (for Hatchback 5 Door): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Always use "Torx" socket wrench E10 when removing the rear seat.

HINT:

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for LH Side) 
  2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY  (See REMOVAL )
  3. REMOVE DECK BOARD SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE DECK FLOOR BOX 
    1. for RH Side:
      1. Remove the deck floor box (See REMOVAL ).
    2. for LH Side:

      HINT:

      Use the same procedure as for the RH side.

  5. REMOVE NO. 1 REAR SEAT LEG COVER (for 60/40 Split Seat Type) 
    1. for RH Side:
      1. Remove the No. 1 rear seat leg cover (See REMOVAL ).
    2. for LH Side:
      1. Remove the No. 1 rear seat leg cover (See REMOVAL ).
  6. REMOVE NO. 2 REAR SEAT LEG COVER (for 60/40 Split Seat Type LH Side)  (See REMOVAL )
  7. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type) 
    1. for RH Side:
      1. Remove the rear seat assembly (See REMOVAL ).
    2. for LH Side:
      1. Remove the rear seat assembly (See REMOVAL ).
  8. REMOVE REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (for Hold Down Seat Type)  (See REMOVAL )
  9. REMOVE REAR SEATBACK ASSEMBLY (for Hold Down Seat Type)  REMOVAL 
  10. REMOVE REAR DOOR SCUFF PLATE  (See REMOVAL )
  11. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP 
    1. Remove the rear door opening trim weatherstrip to the extent that the deck trim side panel and roof side inner garnish can be removed.
  12. REMOVE REAR DECK TRIM COVER  (See REMOVAL )
    Fig 1: Identifying Rear Door Opening Trim Weatherstrip
    G04830718Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. REMOVE DECK TRIM SIDE PANEL ASSEMBLY 
    1. Remove the belt of the rear seat outer belt from the rear seat shoulder belt hanger.
      Fig 2: Identifying Rear Seat Shoulder Belt Hanger Belt
      G04835465Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt.
    3. Disengage the clip and remove the anchor plate of the rear seat outer belt.
      Fig 3: Locating Anchor Plate Clip Bolt
      G04835466Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. for RH side:
      1. Remove the 3 screws.
      2. Disengage the 3 clips and the 6 claws and remove the deck trim side panel.
        Fig 4: Locating Deck Trim Side Panel Clips And Claws
        G04835467Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. for LH side:
      1. Remove the 3 screws.
      2. Disengage the 3 clips and the 6 claws.
      3. Disconnect the luggage compartment room light connector and remove the deck trim side panel.
        Fig 5: Locating Luggage Compartment Room Light Connector
        G04835468Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. REMOVE REAR SEAT SHOULDER BELT HANGER 
    1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the rear seat shoulder belt hanger.
      Fig 6: Disengaging Rear Seat Shoulder Belt Hanger Claws
      G04830723Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  15. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY (for RH Side) 
    1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the center belt guide.
      Fig 7: Disengaging Claws
      G04835472Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. REMOVE ROOF SIDE INNER GARNISH 
    1. for RH Side (w/ Curtain Shield Airbag):
      NOTE: Replace the special clip with a new one because it is damaged when the roof side inner garnish is removed.
      1. Disengage the 5 clips.
      2. Pass the rear seat outer and rear center seat outer belts through the slit in the roof side inner garnish and remove the roof side inner garnish.
        Fig 8: Identifying Roof Side Inner Garnish RH Clips - W/ Curtain Shield Airbag
        G04835473Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. for RH Side (w/o Curtain Shield Airbag):
      1. Disengage the 5 clips.
      2. Pass the rear seat outer and rear center seat outer belts through the slit in the roof side inner garnish and remove the roof side inner garnish.
        Fig 9: Identifying Roof Side Inner Garnish RH Clips - W/O Curtain Shield Airbag
        G04835474Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. for LH Side (w/ Curtain Shield Airbag):
      NOTE: Replace the special clip with a new one because it is damaged when the roof side inner garnish is removed.
      1. Disengage the 5 clips.
      2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.
        Fig 10: Identifying Roof Side Inner Garnish LH Clips - W/ Curtain Shield Airbag
        G04835475Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. for LH Side (w/o Curtain Shield Airbag):
      1. Disengage the 5 clips.
      2. Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.
        Fig 11: Identifying Roof Side Inner Garnish LH Clips - W/O Curtain Shield Airbag
        G04835476Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  17. REMOVE REAR SEAT OUTER BELT ASSEMBLY 
    1. Remove the bolt and the through anchor.
      Fig 12: Locating Anchor Bolt
      G04830729Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt, the 2 hooks and the retractor.
      Fig 13: Locating Hooks And Retractor Bolts
      G04830730Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  18. REMOVE SEAT BELT HOLE SEAL 
    1. Disengage the 2 claws and remove the seat belt hole seal.
scientia non olet · About LEMON Manuals