LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Seat Belt) >> REAR SEAT INNER BELT ASSEMBLY (for Hatchback RH Side) >> Removal

REAR SEAT INNER BELT ASSEMBLY (for Hatchback RH Side): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Always use "Torx" socket wrench E10 when removing the rear seat.
  1. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (for 60/40 Split Seat Type)  (See REMOVAL )
  2. REMOVE DECK BOARD SUB-ASSEMBLY (for 60/40 Split Seat Type)  (See REMOVAL )
  3. REMOVE DECK FLOOR BOX (for 60/40 Split Seat Type)  (See REMOVAL )
  4. REMOVE NO. 1 REAR SEAT LEG COVER (for 60/40 Split Seat Type)  (See REMOVAL )
  5. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type)  (See REMOVAL )
  6. REMOVE REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (for Hold Down Seat Type)  (See REMOVAL )
  7. REMOVE REAR SEAT INNER BELT ASSEMBLY 
    1. for 60/40 Split Seat Type:
      1. Remove the belt from the band.
      2. Remove the bolt and the rear seat inner belt.
        Fig 1: Locating Rear Seat Inner Belt Bolt
        G04834456Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. for Hold Down Seat Type:
      1. Remove the bolt and the rear seat inner belt.
scientia non olet · About LEMON Manuals