FRONT SEAT INNER BELT ASSEMBLY (for Hatchback): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) PRECAUTION .

NOTE: Always use "Torx" socket wrench E10 when installing the front seat.

HINT:

The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.

Fig 1: Measuring Resistance Between Terminals

INSTALL FRONT SEAT INNER BELT ASSEMBLY
1. for Driver Side:
  1. Install the front seat inner belt with the bolt.
    Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
    
    NOTE: Do not place the front seat inner belt over the convex areas of the front seat adjuster frame.
  2. Install the wire harness into the claw of the front seat cushion shield.
    
    Fig 2: Identifying Front Seat Inner Belt Bolt
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. Install the 2 wiring harness clamps.
  4. Install the buckle switch connector.
  5. Connect the seat position sensor connector.
    
    Fig 3: Locating Wiring Harness Clamps
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. for Front Passenger Side:
  1. Install the front seat inner belt with the bolt.
    Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
    
    NOTE: Do not place the front seat inner belt over the convex areas of the front seat adjuster frame.
  2. Install the wiring harness onto the claw of the front seat cushion shield.
    
    Fig 4: Identifying Front Seat Inner Belt Bolt
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. Install the 2 wiring harness clamps.
  4. Install the buckle switch connector.
INSTALL FRONT SEAT ASSEMBLY (See INSTALLATION )
INSTALL FRONT SEAT HEADREST ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)
DIAGNOSIS SYSTEM

Fig 5: Locating Wiring Harness Clamps
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002