Rear Axle Hub Bolt: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR AXLE HUB BOLT
1. Install the washer and the nut onto a new hub bolt.
2. Using a screwdriver or the equivalent to hold the hub and bearing, install the hub bolt by tightening the nut.
  
  Fig 1: Identifying Rear Axle Hub Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
ADJUST REAR DRUM BRAKE SHOE CLEARANCE (See INSTALLATION )
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)