Rear Axle Hub And Bearing: Installation
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
- Install the axle hub and bearing onto the axle beam with the 4 bolts.
Torque: 90 N*m (918 kgf*cm, 67 ft.*lbf)
- Install the axle hub and bearing onto the axle beam with the 4 bolts.
- INSPECT REAR AXLE HUB BEARING (See ON-VEHICLE INSPECTION )
- CONNECT SKID CONTROL SENSOR WIRE (w/ ABS)
- Connect the skid control sensor wire connector.
- INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
- ADJUST REAR DRUM BRAKE SHOE CLEARANCE (See INSTALLATION )
- INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
- CHECK ABS SENSOR SIGNAL (w/ ABS) (See TEST MODE PROCEDURE )