Clutch Master Cylinder: Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE BRAKE BOOSTER ASSEMBLY (See REMOVAL )
REMOVE CLUTCH RESERVOIR TUBE
1. Loosen the clip and remove the clutch reservoir tube from the clutch master cylinder assembly.
  HINT:
  
  Use a container to collect the fluid.
DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE
1. Using SST, disconnect the flexible hose tube.
  SST 09023-00101
  
  HINT:
  
  Use a container to collect the fluid.
Fig 1: Locating Flexible Hose Tube
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1 (See REMOVAL )
REMOVE CLUTCH MASTER CYLINDER ASSEMBLY
1. Remove the 2 nuts and the clutch master cylinder.
  
  Fig 2: Locating Clutch Master Cylinder Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS
1. Measure dimension A as shown in Fig 3 before loosening the lock nut.
2. Loosen the lock nut and remove the push rod clevis.
3. Remove the lock nut.
  
  Fig 3: Measuring Clutch Master Cylinder Push Rod Dimension
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002