POWER OUTLET SOCKET (for Hatchback): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL POWER OUTLET SOCKET COVER
1. Engage the 2 claws and install a new power outlet socket cover.
  
  Fig 1: Identifying Power Outlet Socket Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL POWER OUTLET SOCKET
1. Align the protrusion of the power outlet socket with the cutout of the power outlet socket cover and install the power outlet socket.
2. Securely engage the claw.
  
  Fig 2: Aligning Protrusion Of Power Outlet Socket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the power outlet socket connector.
  
  Fig 3: Locating Power Outlet Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY (See INSTALLATION )
CONNECT DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY (See INSTALLATION )
CONNECT AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY (See INSTALLATION )
INSTALL AIR CONDITIONING PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER (See INSTALLATION )
INSTALL INSTRUMENT CLUSTER FINISH PANEL (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL END RH (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL END LH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)