CONDENSER (for Hatchback): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM (See ON-VEHICLE INSPECTION )
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT BUMPER COVER REMOVAL
REMOVE RADIATOR SUPPORT ABSORBER UPPER (See REMOVAL )
REMOVE NO. 1 COOLER COVER (See REMOVAL )
SEPARATE HOOD LOCK ASSEMBLY (w/ Theft Deterrent System) (See REMOVAL )
SEPARATE HOOD LOCK ASSEMBLY (w/o Theft Deterrent System) (See REMOVAL )
REMOVE RADIATOR SUPPORT SUB-ASSEMBLY UPPER (See REMOVAL )
DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
1. Remove the bolt and disconnect the discharge hose from the cooler condenser.
2. Remove the O-ring from the discharge hose.
  NOTE: Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.
  
  Fig 1: Disconnecting Discharge Hose From Cooler Condenser
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT LIQUID TUBE SUB-ASSEMBLY A
1. Remove the bolt and disconnect the liquid tube from the cooler condenser.
2. Remove the O-ring from the liquid tube.
  NOTE: Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.
  
  Fig 2: Disconnecting Liquid Tube From Cooler Condenser
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CONDENSER
1. Disengage the 2 claws and remove the condenser from the vehicle.
  NOTE: Do not damage the condenser or radiator when removing the condenser.
  
  Fig 3: Installing Condenser
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002