Blower Resistor: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL BLOWER RESISTOR
1. Install the blower resistor with the 2 screws.
2. Connect the connector.
  
  Fig 1: Identifying Screws And Blower Resistor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the floor carpet.
INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY RH (for Hatchback) (See INSTALLATION )
INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY RH (for Sedan) (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Fig 2: Connecting Cable To Negative Battery Terminal
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)