AIR CONDITIONING PANEL ASSEMBLY (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER (See REMOVAL )
REMOVE INSTRUMENT PANEL FINISH PANEL END LH (SeeREMOVAL )
REMOVE INSTRUMENT PANEL FINISH PANEL END RH (See REMOVAL )
REMOVE INSTRUMENT CLUSTER FINISH PANEL (See REMOVAL )
REMOVE RADIO RECEIVER ASSEMBLY
REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER SUB-ASSEMBLY
1. Disengage the 2 claws and 4 clips and remove the instrument cluster finish panel center.
  
  Fig 1: Locating Instrument Cluster Panel Center Claws And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE AIR CONDITIONING PANEL ASSEMBLY
1. Disengage the 4 clips and 2 claws and remove the air conditioning panel.
  
  Fig 2: Removing Air Conditioning Panel
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the 3 connectors and 4 clamps.
  
  Fig 3: Disconnecting Connectors And Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY
1. Disconnect the air mix damper control cable from the clamp.
2. Disengage the 2 claws and disconnect the air mix damper control cable.
  
  Fig 4: Disconnecting Air Mix Damper Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY
1. Disengage the 2 claws and disconnect the defroster damper control cable.
  
  Fig 5: Disconnecting Defroster Damper Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY
1. Disengage the 2 claws and disconnect the air inlet damper control cable.
  
  Fig 6: Disconnecting Air Inlet Damper Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002