LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Supplemental Restraint System) >> SIDE AIRBAG SENSOR (for 3 Door) >> Installation

SIDE AIRBAG SENSOR (for 3 Door): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
NOTE: Always use "Tone" socket wrench E10 when installing the rear seat.

HINT:

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

  1. INSTALL SIDE AIRBAG SENSOR 
    1. Confirm that the ignition switch is turned to OFF.
    2. Confirm that the negative battery terminal is detached.
      CAUTION:
      • Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
      Fig 1: Identifying Side Airbag Sensor
      G04830463Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Insert the hook into the body hole and install the airbag sensor with the bolt.

      Torque: 9.0 N*m (90 kgf*cm, 80 in.*lbf) 

      NOTE:
      • Do not use a side airbag sensor that has been dropped.
      • Do not subject the side airbag sensor to any impact or force.
    4. Confirm that there is no looseness by shaking the side airbag sensor.
    5. Connect the airbag connector.
      6. Fig 2: Connecting Airbag Connector
      G04830465Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH  (See INSTALLATION )
  3. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH  (See INSTALLATION )
  4. INSTALL FRONT DOOR SCUFF PLATE RH  (See INSTALLATION )
  5. INSTALL REAR SEAT ASSEMBLY LH (for 60/40 Split Seat Type)  (See INSTALLATION )
  6. INSTALL REAR SEAT ASSEMBLY RH (for 60/40 Split Seat Type)  INSTALLATION 
  7. INSTALL NO. 2 REAR SEAT LEG COVER (for 60/40 Split Seat Type)  (See INSTALLATION )
  8. INSTALL NO. 1 REAR SEAT LEG COVER (for 60/40 Split Seat Type)  (See INSTALLATION )
  9. INSTALL REAR SEATBACK ASSEMBLY (for Hold Down Seat Type)  INSTALLATION 
  10. INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (for Hold Down Seat Type)  INSTALLATION 
  11. INSTALL DECK FLOOR BOX RH  (See INSTALLATION )
  12. INSTALL DECK FLOOR BOX LH  (See INSTALLATION )
  13. INSTALL DECK BOARD SUB-ASSEMBLY  (See INSTALLATION )
  14. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY  (See INSTALLATION )
  15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

  16. INSPECT SRS WARNING LIGHT 

    (See DIAGNOSIS SYSTEM  )

scientia non olet · About LEMON Manuals