REAR AIRBAG SENSOR (for Sedan): Removal
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See AIRBAG SYSTEM
).
HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- REMOVE REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (See REMOVAL )
- REMOVE REAR SEATBACK ASSEMBLY RH (for 60/ 40 Split Seat Type) (See REMOVAL )
- REMOVE REAR SEATBACK ASSEMBLY LH (for 60/ 40 Split Seat Type) (See REMOVAL )
- REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type) REMOVAL
- REMOVE LUGGAGE COMPARTMENT FLOOR MAT (for 60/40 Split Seat Type) (See DISASSEMBLY )
- REMOVE SPARE WHEEL COVER ASSEMBLY (for 60/ 40 Split Seat Type) (See DISASSEMBLY )
- REMOVE LUGGAGE COMPARTMENT TRIM INNER PAD (for 60/40 Split Seat Type) (See DISASSEMBLY )
- REMOVE REAR DOOR SCUFF PLATE RH (See REMOVAL )
- REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH (See REMOVAL )
- REMOVE REAR SEAT SIDE COVER RH (See REMOVAL )
- REMOVE REAR AIRBAG SENSOR CAUTION: Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
- Slide the outer housing and detach the airbag connector.
- Disengage the bolt and hook and remove the airbag sensor.