LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Supplemental Restraint System) >> REAR AIRBAG SENSOR (for 5 Door) >> Removal

REAR AIRBAG SENSOR (for 5 Door): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Some of the these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See AIRBAG SYSTEM  ).
NOTE: Always use "Tone" socket wrench E10 when installing the rear seat.

HINT:

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY  (See REMOVAL )
  3. REMOVE DECK BOARD SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE DECK FLOOR BOX RH  (See REMOVAL )
  5. REMOVE DECK FLOOR BOX LH  (See REMOVAL )
  6. REMOVE NO. 1 REAR SEAT LEG COVER (for 60/40 Split Seat Type)  (See REMOVAL )
  7. REMOVE NO. 2 REAR SEAT LEG COVER (for 60/40 Split Seat Type)  (See REMOVAL )
  8. REMOVE REAR SEAT ASSEMBLY RH (for 60/40 Split Seat Type)  (See REMOVAL )
  9. REMOVE REAR SEAT ASSEMBLY LH (for 60/40 Split Seat Type)  (See REMOVAL )
  10. REMOVE REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (for Hold Down Seat Type)  (See REMOVAL )
  11. REMOVE REAR SEATBACK ASSEMBLY (for Hold Down Seat Type)  REMOVAL 
  12. REMOVE REAR DECK TRIM COVER  (See REMOVAL )
  13. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH 
    1. Remove the rear opening trim weatherstrip to the extent necessary to remove the deck trim side panel.
  14. REMOVE REAR SEAT OUTER BELT ASSEMBLY RH  (See REMOVAL )
    Fig 1: Identifying Rear Opening Trim Weatherstrip
    G04830488Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  15. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH 
    1. Remove the 3 screws.
    2. Disengage the 3 clips and the 6 claws and remove the deck trim side panel.

      HINT:

      When removing the deck trim side panel assembly LH, disconnect the room light connector and remove the deck trim side panel.

  16. REMOVE REAR AIRBAG SENSOR 
    CAUTION: Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
    Fig 2: Locating Deck Trim Side Panel
    G04830489Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Slide the outer housing and detach the airbag connector.
      Fig 3: Detaching Airbag Connector
      G04830490Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the bolt and hook and remove the airbag sensor.
      3. Fig 4: Identifying Airbag Sensor Bolt
      G04830482Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals