NO. 2 BLACK OUT TAPE (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The procedure described below is for the LH side. Use the same procedure for the RH and LH sides, unless otherwise specified.

INSTALL NO. 2 BLACK OUT TAPE

Application precautions (See INSTALLATION ).
Clean the attachment surface (Using an infrared light) (See INSTALLATION ).
Clean the attachment surface (Using a tape removal disc) (See INSTALLATION ).

Apply new No. 1 black out tape to the positions shown in the illustration.

Fig 1: No. 1 Black Out Tape Positions Chart

Installation position

MARK MEASUREMENT CHART

Mark	Measurement (along surface)
a	+-1 mm (+-0.039 in.)
b	0 to 0.8 mm (0 to 0.032 In.)
c	2 mm (0.079 In.)
d	2 to 4mm (0.079 to 0.157 In.)
e	3 to 5 mm (0.118 to 0.197 In.)

INSTALL REAR DOOR GLASS RUN REASSEMBLY
INSTALL REAR DOOR BELT MOLDING (See REMOVAL )
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY REASSEMBLY
INSTALL REAR DOOR ARMREST BASE UPPER PANEL REASSEMBLY
INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) REASSEMBLY
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Power Window)
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)