NO. 2 BLACK OUT TAPE (for Hatchback): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

INSTALL NO. 2 BLACK OUT TAPE

Precautions during application (See INSTALLATION ).
Clean the attachment surface (using an infrared light) (See INSTALLATION ).
Clean the attachment surface (using a tape removal disc) (See INSTALLATION ).

Apply a new black out tape to the positions shown in the illustration.

Fig 1: Black Out Tape Positions Chart

Installation position

MARK MEASUREMENT CHART

Mark	Measurement (along surface)
a	+-1 mm (+-0.039 In.)
b	0 to 1.8 mm (0 to 0.071 In.)
c	2 mm (0.079 in.)
d	1.2 to 3.2 mm (0.047 to 0.126 In.)
e	2 to 4 mm (0.079 to 0.157 In.)

INSTALL REAR DOOR GLASS RUN REASSEMBLY
INSTALL REAR DOOR BELT MOLDING (See REMOVAL )
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
1. w/ Power Window:
  1. Install the rear door trim board sub-assembly REASSEMBLY .
2. w/o Power Window:
  1. Install the rear door trim board sub-assembly (See REASSEMBLY ).
INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) (See REASSEMBLY )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Power Window)
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)