FRONT BUMPER (for Sedan): Reassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT BUMPER HOLE COVER
1. Engage the 3 claws and install the front bumper hole cover.
  
  Fig 1: Identifying Claws Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FOG LIGHT COVER LH
1. w/ Fog Light:
  1. Engage the 4 claws and install the fog light cover.
    
    Fig 2: Identifying Claws And Fog Light Cover
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. w/o Fog Light:
  1. Engage the 4 claws and install the fog light cover.
INSTALL FOG LIGHT COVER RH
HINT:

Use the same procedure as for the LH side.

Fig 3: Identifying Claws And Fog Light Cover
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FOG LIGHT ASSEMBLY LH (w/ Fog Light)
1. Install the fog light with the 3 screws.
INSTALL FOG LIGHT ASSEMBLY RH (w/ Fog Light)
HINT:

Use the same procedure as for the LH side.

Fig 4: Locating Screws And Fog Light
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL RADIATOR LOWER GRILLE
1. Engage the 12 claws and install the radiator lower grille.
  
  Fig 5: Identifying Claws Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL RADIATOR GRILLE
1. Engage the 13 claws and install the radiator grille.
2. Tighten the 2 screws.
INSTALL RADIATOR GRILLE EMBLEM (See INSTALLATION )

Fig 6: Identifying Claws Location
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002