FRONT BUMPER (for Sedan): Disassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE RADIATOR GRILLE EMBLEM (See REMOVAL )

Fig 1: Locating Bolts And Front Bumper Arm
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE RADIATOR GRILLE
1. Remove the 2 screws.
2. Using a screwdriver, disengage the 13 claws and remove the radiator grille.
  
  Fig 2: Identifying Claws Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE RADIATOR LOWER GRILLE
1. Disengage the 12 claws and remove the radiator lower grille.
  
  Fig 3: Identifying Claws Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)
1. Remove the 3 screws and the fog light.
REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)
HINT:

Use the same procedure as for the LH side.

Fig 4: Locating Screws And Fog Light
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FOG LIGHT COVER LH
1. w/ Fog Light:
  1. Disengage the 4 claws and remove the fog light cover.
    
    Fig 5: Identifying Claws And Fog Light Cover
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. w/o Fog Light:
  1. Disengage the 4 claws and remove the fog light cover.
REMOVE FOG LIGHT COVER RH
HINT:

Use the same procedure as for the LH side.

Fig 6: Identifying Claws And Fog Light Cover
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT BUMPER HOLE COVER
1. Disengage the 3 claws and remove the front bumper hole cover.
  
  Fig 7: Identifying Claws Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002