FRONT BUMPER (for Hatchback): Reassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT BUMPER HOLE COVER
1. Engage the 3 claws and install the front bumper hole cover.
  
  Fig 1: Identifying Claws Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FOG LIGHT COVER LH
1. w/ Fog Light:
  1. Engage the 5 claws and install the fog light cover.
    
    Fig 2: Identifying Claws Location
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. w/o Fog Light:
  1. Engage the 5 claws and install the fog light cover.
INSTALL FOG LIGHT COVER RH
HINT:

Use the same procedure as for the LH side.

Fig 3: Identifying Claws Location
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FOG LIGHT ASSEMBLY LH
1. Install the fog light with the screw.
INSTALL FOG LIGHT ASSEMBLY RH
HINT:

Use the same procedure as for the LH side.

Fig 4: Locating Screw And Fog Light
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL RADIATOR LOWER GRILLE
1. Engage the 11 claws and install the radiator lower grille.
  
  Fig 5: Identifying Claws Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL RADIATOR GRILLE
1. Engage the 14 claws and install the radiator grille.
INSTALL RADIATOR GRILLE EMBLEM (See INSTALLATION )

Fig 6: Identifying Claws Location
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT BUMPER PAD
1. Install the front bumper pad.
  
  Fig 7: Identifying Front Bumper Pad
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002