HEADLIGHT ASSEMBLY (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
Set the headlight leveling switch to 0 (zero) before conducting the procedure.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT SPOILER COVER (w/ Front Spoiler) REMOVAL
REMOVE FRONT BUMPER COVER REMOVAL
REMOVE HEADLIGHT ASSEMBLY
1. Remove the 2 screws and the bolt.
2. Disconnect the 2 connectors, then remove the headlight.
  
  Fig 1: Locating Headlight Screws And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002