FRONT DOOR COURTESY SWITCH (for Hatchback): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT DOOR COURTESY SWITCH
1. Connect the connector.
2. Using "Torx" socket wrench T30, install the front door courtesy switch with the screw.
  Torque: 3.7 N*m (38 kgf*cm, 33 in.*lbf)
INSTALL CENTER PILLAR GARNISH LOWER (for 5 Door) (See INSTALLATION )

Fig 1: Locating Front Door Courtesy Switch Screw
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP (for 5 Door)
1. Install the rear door opening trim weatherstrip.
  
  Fig 2: Locating Rear Door Opening Trim Weatherstrip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
1. Install the front door opening trim weatherstrip.
INSTALL REAR DOOR SCUFF PLATE (for 5 Door) (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE (for 5 Door) (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE (for 3 Door) (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

Fig 3: Locating Front Door Opening Trim Weatherstrip
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002