REAR DOOR LOCK (for Sedan): Removal

HINT:

• Use the same procedure for both the RH and LH sides.
• The procedure described below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)  (See DISASSEMBLY )
3. REMOVE REAR DOOR ARMREST BASE UPPER PANEL  (See DISASSEMBLY )
4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY  (See DISASSEMBLY )
5. REMOVE REAR DOOR TRIM BRACKET  (See DISASSEMBLY )
6. REMOVE REAR DOOR SERVICE HOLE COVER  (See DISASSEMBLY )
7. REMOVE REAR DOOR CHECK ASSEMBLY  (See DISASSEMBLY )
8. REMOVE REAR DOOR WEATHERSTRIP  (See DISASSEMBLY )
9. REMOVE REAR DOOR BELT MOULDING  (See REMOVAL )
10. REMOVE REAR DOOR GLASS RUN  (See DISASSEMBLY )
11. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY  (See DISASSEMBLY )
12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY  (See DISASSEMBLY )
13. REMOVE REAR DOOR LOCK 
    1. Using "Torx" socket wrench T30, remove the 3 screws.
       NOTE: Do not drop or damage the rear door lock when removing the screws.
    2. Move the rear door lock downward, remove the outside handle frame release plate and remove the rear door lock.

       HINT:

       Remove the rear door lock through the service hole.

       Fig 1: Locating "Torx" Screw

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Open the 2 covers.
       Fig 2: Locating Covers

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the rear door lock remote control cable and rear door inside locking cable.
    5. Remove the door lock wire harness seal.
       Fig 3: Locating Rear Door Lock Remote Control Cable And Rear Door Inside Locking Cable

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002