REAR DOOR LOCK (for Hatchback): Removal

HINT:

• Use the same procedure for both the RH and LH sides.
• The procedure listed below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
2. REMOVE DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)  (See DISASSEMBLY )
3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY  (See DISASSEMBLY )
4. REMOVE REAR DOOR SERVICE HOLE COVER  (See DISASSEMBLY )
5. REMOVE REAR DOOR CHECK ASSEMBLY  (See DISASSEMBLY )
6. REMOVE REAR DOOR WEATHERSTRIP  (See DISASSEMBLY )
7. REMOVE REAR DOOR BELT MOULDING  REMOVAL 
8. REMOVE REAR DOOR GLASS RUN  (See DISASSEMBLY )
9. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY  (See DISASSEMBLY )
10. REMOVE REAR DOOR QUARTER WINDOW WEATHERSTRIP  (See DISASSEMBLY )
11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY  (See DISASSEMBLY )
12. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY (w/ Power Window)  (See DISASSEMBLY )
13. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY (w/o Power Window)  DISASSEMBLY 
14. REMOVE REAR DOOR LOCK ASSEMBLY 
    1. Using "Torx" socket wrench T30, remove the 3 screws.
    2. Move the rear door lock downward, remove the outside handle frame release plate and remove the rear door lock.
       Fig 1: Locating "Torx" Screw

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the 7 claws and open the 2 covers.
       Fig 2: Locating Covers

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the rear door lock remote control cable and the rear door inside locking cable.
    5. Remove the door lock wire harness seal.
       Fig 3: Locating Rear Door Lock Remote Control Cable And Rear Door Inside Locking Cable

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002