REAR DOOR LOCK (for Hatchback): Installation
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL REAR DOOR LOCK ASSEMBLY NOTE:
- If reusing a door lock that has been removed, replace the packing in the connecting part with new.
- Make sure that no grease and dirt adheres to the packing surface in the connecting part.
- Apply MP grease to the sliding and rotating areas of the front door lock.
- Connect the rear door lock remote control cable and the rear door inside locking cable.
- Engage the 7 claws and close the 2 covers.
- Insert the door lock into the outside handle frame release plate, then set it onto the door panel.
- Make sure that the outside handle frame link is securely engaged with the door lock.
- Apply adhesive to the threads of the screws.
Adhesive:
Part No. 08833-00070, THREE BOND 1324 or the equivalent
- Using "Torx" socket wrench T30, install the rear door lock with the 3 screws.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
- INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY (w/ Power Window) (See REASSEMBLY )
- INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY (w/o Power Window) (See REASSEMBLY )
- INSTALL REAR DOOR GLASS SUB-ASSEMBLY (See REASSEMBLY )
- INSTALL REAR DOOR QUARTER WINDOW WEATHERSTRIP (See REASSEMBLY )
- INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY (See REASSEMBLY )
- INSTALL REAR DOOR GLASS RUN REASSEMBLY
- INSTALL REAR DOOR BELT MOULDING INSTALLATION
- INSTALL REAR DOOR WEATHERSTRIP REASSEMBLY
- INSTALL REAR DOOR CHECK ASSEMBLY REASSEMBLY
- INSTALL REAR DOOR SERVICE HOLE COVER REASSEMBLY
- INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY REASSEMBLY
- INSTALL DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) (See REASSEMBLY )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)