REAR DOOR BELT MOLDING (for Hatchback): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

Fig 1: Identifying Rear Door Belt Molding

INSTALL REAR DOOR BELT MOLDING
1. Engage the 5 claws and the clip and install a new rear door belt molding.
  
  Fig 2: Identifying Claws Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the protective tape.
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
1. w/ Power Window:
  1. Install the rear door trim board sub-assembly REASSEMBLY .
2. w/o Power Window:
  1. Install the rear door trim board sub-assembly (See REASSEMBLY ).
INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) (See REASSEMBLY )

Fig 3: Applying Protective Tape To Door Panel
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Power Window)
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)