BACK DOOR LOCK (for Hatchback): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL BACK DOOR LOCK ACTUATOR ASSEMBLY
1. Install the back door lock actuator with the 2 bolts.
  Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)
2. Connect the connector.
  
  Fig 1: Locating Bolts And Back Door Lock Actuator
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BACK DOOR LOCK ASSEMBLY
1. Install the back door lock with the 3 bolts.
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
2. Connect the connector and clamp.
INSTALL BACK DOOR TRIM BOARD ASSEMBLY (See REASSEMBLY )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

Fig 2: Locating Connector And Clamp
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002