LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 159 (Seat) >> Seat Heater Switch >> Removal

Seat Heater Switch: Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE SWITCH BASE (See appropriate step(s) under  REMOVAL  ) 
  3. REMOVE SEAT HEATER SWITCH 
    1. Using a screwdriver, detach the 2 claws and remove the switch.

      HINT:

      Tape the screwdriver tip before use.

      Fig 1: Removing Seat Heater Switch
      G04491980Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals