Parking Brake Lever: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL PARKING BRAKE SWITCH ASSEMBLY
1. Install the parking brake switch with the screw.
  Torque: 0.88 N*m (9.0 kgf*cm, 7.8 in.*lbf)
INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY
1. Connect the cable to the lever.
INSTALL PARKING BRAKE LEVER SUB-ASSEMBLY
1. Install the parking brake lever (with the No. 1 parking brake cable) with the 2 bolts.
  Torque: 14.5 N*m (148 kgf*cm, 11 ft.*lbf)
  
  Fig 1: Installing Parking Brake Lever (With The No. 1 Parking Brake Cable)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the No. 1 parking brake cable to the parking brake equalizer.
  
  Fig 2: Connecting Parking Brake Cable To Parking Brake Equalizer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Temporarily install the wire adjusting nut and lock nut.
  
  Fig 3: Identifying Wire Adjusting Nut And Lock Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the parking brake switch connector.
CHECK PARKING BRAKE LEVER TRAVEL (See PARKING BRAKE SYSTEM )
ADJUST PARKING BRAKE LEVER TRAVEL (See ADJUSTMENT )
INSTALL REAR CONSOLE BOX SUB-ASSEMBLY
1. Install the rear console box (see step 9 under INSTALLATION ).
  HINT:
  
  Refer to the procedures from the installation of the rear console box sub-assembly up until the installation of the No. 1 console upper panel garnish. (See step 9 under INSTALLATION ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL