Inspection Procedure

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

When replacing the tire pressure warning ECU and receiver, read the IDs stored in the old ECU using the intelligent tester and write them down before removal.
It is necessary to perform initialization (see INITIALIZATION ) after registration (see REGISTRATION ) of the transmitter IDs into the tire pressure warning ECU and receiver after the ECU has been replaced.

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER
HINT:

Replace tire pressure warning ECU and receiver (see REPLACEMENT ).

NEXT: END