Throttle Body: Installation

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL THROTTLE BODY
1. Install a new gasket and the throttle body with the 3 bolts and nut.
  Torque: 14 N*m (142 kgf*cm, 10 ft.*lbf)
  
  Fig 1: Locating Bolts, Nut And Throttle Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the 2 water bypass hoses.
3. Connect the throttle position sensor and control connector.
INSTALL INTAKE AIR CONNECTOR PIPE (see INSTALLATION )
INSTALL V-BANK COVER SUB-ASSEMBLY (see CAMSHAFT POSITION SENSOR )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Fig 2: Locating Water By-Pass Hoses
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
PERFORM INITIALIZATION
CAUTION: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
ADD ENGINE COOLANT (See REPLACEMENT )
CHECK FOR ENGINE COOLANT LEAKS
1. Check for engine coolant leaks (see REPLACEMENT ).