Camshaft Timing Oil Control Valve Assembly: Installation

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 1)
1. Install a new O-ring to the oil control valve.
2. Apply light coat of engine oil to the O-ring.
3. Install the oil control valve with the bolt.
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
4. Connect the oil control valve connector.
Fig 1: Locating Bolt And Oil Control Valve
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 2)
1. Install a new O-ring to the oil control valve.
2. Install the oil control valve with the bolt.
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
3. Connect the oil control valve connector.
Fig 2: Locating Bolt And Oil Control Valve
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INTAKE AIR CONNECTOR PIPE
1. Install the intake air connector pipe with the 2 clamp bolts and 2 bolts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
2. Connect the 3 hoses.
INSTALL V-BANK COVER SUB-ASSEMBLY
1. Install the V-bank cover with the 2 nuts and 2 bolts.
Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform INITIALIZATION .
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.