Camshaft Position Sensor: Removal
WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- DRAIN ENGINE COOLANT (See REPLACEMENT )
- REMOVE V-BANK COVER SUB-ASSEMBLY (see REMOVAL )
- REMOVE INTAKE AIR CONNECTOR PIPE (see REMOVAL )
- DISCONNECT NO. 1 RADIATOR HOSE (See REMOVAL )
- REMOVE NO. 3 TIMING BELT COVER SUB-ASSEMBLY BANK 1 (See REMOVAL )
- REMOVE CAMSHAFT POSITION SENSOR
- Remove the bolt, stud bolt and camshaft position sensor.