Camshaft Position Sensor: Installation

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CAMSHAFT POSITION SENSOR
1. Install the camshaft position sensor with the bolt and stud bolt.
Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
INSTALL NO. 3 TIMING BELT COVER SUB-ASSEMBLY BANK 1 (See INSTALLATION )
CONNECT NO. 1 RADIATOR HOSE (See INSTALLATION )

Fig 1: Locating Bolt, Stud Bolt And Camshaft Position Sensor
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INTAKE AIR CONNECTOR PIPE (see INSTALLATION )
INSTALL V-BANK COVER SUB-ASSEMBLY (see INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform INITIALIZATION .
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
ADD ENGINE COOLANT (See REPLACEMENT )
CHECK FOR ENGINE COOLANT LEAKS
1. Check for engine coolant leaks (see REPLACEMENT ).